DS1337S+C01【PDF 3/16 页】IC RTC SERIAL 2WIRE LP 8-SOIC

您好，
买卖IC网欢迎您。
请登录
免费注册

Sheet目录1993

DS1337 I

2C Serial Real-Time Clock

Bit 1: Alarm 2 Interrupt Enable (A2IE). When set to logic 1, this bit permits the alarm 2 flag (A2F) bit in the status

INTA (when INTCN = 0) or to assert SQW/INTB (when INTCN = 1). When the A2IE bit is set to

logic 0, the A2F bit does not initiate an interrupt signal. The A2IE bit is disabled (logic 0) when power is first

applied.

Bit 0: Alarm 1 Interrupt Enable (A1IE). When set to logic 1, this bit permits the alarm 1 flag (A1F) bit in the status

INTA. When the A1IE bit is set to logic 0, the A1F bit does not initiate the INTA signal. The A1IE

bit is disabled (logic 0) when power is first applied.

Status Register (0Fh)

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

OSF

A2F

A1F

Bit 7: Oscillator Stop Flag (OSF). A logic 1 in this bit indicates that the oscillator either is stopped or was stopped

for some period of time and may be used to judge the validity of the clock and calendar data. This bit is set to logic

1 anytime that the oscillator stops. The following are examples of conditions that can cause the OSF bit to be set:

1) The first time power is applied.

2) The voltage present on VCC is insufficient to support oscillation.

3) The

EOSC bit is turned off.

4) External influences on the crystal (e.g., noise, leakage, etc.).

This bit remains at logic 1 until written to logic 0.

Bit 1: Alarm 2 Flag (A2F). A logic 1 in the alarm 2 flag bit indicates that the time matched the alarm 2 registers.

This flag can be used to generate an interrupt on either

INTA or SQW

/INTB depending on the status of the INTCN

bit in the control register. If the INTCN bit is set to logic 0 and A2F is at logic 1 (and A2IE bit is also logic 1), the

INTA pin goes low. If the INTCN bit is set to logic 1 and A2F is logic 1 (and A2IE bit is also logic 1), the SQW/INTB

pin goes low. A2F is cleared when written to logic 0. This bit can only be written to logic 0. Attempting to write to

logic 1 leaves the value unchanged.

Bit 0: Alarm 1 Flag (A1F). A logic 1 in the alarm 1 flag bit indicates that the time matched the alarm 1 registers. If

the A1IE bit is also logic 1, the

INTA pin goes low. A1F is cleared when written to logic 0. This bit can only be

written to logic 0. Attempting to write to logic 1 leaves the value unchanged.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式